What are the common problems with the three in one pure water filling machine?

The three in one pure water filling machine belongs to the category of packaging machinery. Do you want to know how to choose a filling machine? The filling machine is mainly divided into three parts: storage tank, filling host, and variable frequency speed control transmission module. The filling box of the filling machine is located at the top of the equipment. It is a constant pressure system with a liquid level sensor and a feed solenoid valve. The liquid material conveyed in the previous process enters the storage tank through an electromagnetic valve. When the appropriate liquid level is reached, the liquid level sensor will send a signal to close and stop feeding; When the material surface drops to a position, it automatically opens. Input solenoid valve. At the lower part of the storage tank, the discharge port is connected to the suction pipe of the liquid filling host through a pipeline. When the host is working, the liquid in the storage tank of the filling machine is sucked into the piston cylinder and injected into the bottle through a nozzle.

1、 After closing and using, there is a phenomenon of floor drain. If users find that the equipment has floor drains after production, they should proceed with the following actions.

First, check if the filling nozzle orifice is damaged, and then remove the filling nozzle to repair the orifice. The diameter of the orifice should be less than 7.5mm. After repairing the aperture, gently grind the flat surface of the aperture on a water sanded paper. Check again if the ball valve inside the filling head is damaged, and replace the ball valve promptly if damaged.

2、 The crank of the water bottle packaging machine does not operate properly after starting up. What should be done in this situation?

The fixing rod on the filling machine is leaning downwards, and the inner and outer tubes of the syringe are firmly pressed when pushing the liquid, causing the crank to not rotate. The nut should be loosened, and the upper fixing rod should be moved up to the appropriate position before tightening the nut. If the inner and outer tubes are not clean during the assembly of the syringe and become stuck, the syringe needs to be removed for cleaning. Observe the end of the injection system at the bearing area. If it cannot function properly, it needs to be reinstalled.

3、 The equipment has a faulty capacity error, or the capacity error is significant. It is reported that in this situation, it is generally necessary for the user to make adjustments.

There is air in the liquid pipe of the filling machine, and users can press the foot switch multiple times to exhaust; If the inlet pipeline is not tightly sealed and there is air leakage, it is necessary to tighten the connecting pipe; If the operation or filling speed is too fast, slow down the speed appropriately; If the liquid level in the material cylinder is low, it will keep the liquid level at 1.52 meters. In addition, when filling large specifications, if the material tank is not filled enough, resulting in unstable liquid level, users can increase the amount of filling or close the ball valve above the filling head again, and reset the filling time.